Pin Style Flywheel Holder Tool Engine In order for this to

In order for this to work on a 03-09 KLX110 you will need to use a 2010+ stock crank shaft and timing chain OR you can run the TBW9182 55mm Stroker crank kit

The combination of the 141 bore kit and the proven VM26mm carb results in very impressive power and performance over your stock engine

In order for this kit to work on a 03-09 KLX110 you will need to use a 2010+ stock crank shaft and timing chain OR you can run the TBW9182 55mm Stroker crank kit

52mm replacement piston ring set for TB Parts short rod pistons TBW0219

**This MAY be a special order item from Japan

Pin Style Flywheel Holder Tool Engine In order for this toPin Style Flywheel Holder Tool Works to hold the crf110 cam gear. And many other uses. Details The Tusk flywheel rotor holder tool keeps flywheels, rotors, and sprockets from rotating during removal and installation. It holds parts with holes (center to center) at a minimum distance of 13mm and a maximum distance of 230mm. One side of the holder is equipped with 5mm diameter pins and on the opposite side has 9mm pins. The holder is held open at a set