1-1/2" PVC Push Point Compression Points without removing the point

without removing the point

This allows the hole to be opened from a shallow hole on the edge of the sidewalk and then travel deeper to clear the bottom of the curb and gutter and exit into the micro trench or pot hole in the road

or If there is no bell housing then a coupling must be glued onto the pipe and the part inserted into the coupling

Connect the nozzle to the end of a garden hose and insert it through the hole all the way to the exit pit then

As the shafts are extracted the tape or line is pulled into the hole which can then be attached to the microduct and installed

1-1/2" PVC Push Point Compression Points without removing the pointThis part is used to insert a 1 1 2" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. It is threaded into the end of a 2 sch 40 PVC pipe or conduit. As it is screwed into the pipe it cuts its own threads on the inside of the pipe much like a tap. The outside diameter of the push point will be the same as the outside diameter of the pipe itself. Next this pipe point assembly is shoved into the same opening