Products and systems for the protection and repair of concrete structures. Test methods - Determination of the adhesion of injection products, with or without thermal cycling. Adhesion by tensile bond strength has-corrigendum BS EN 10217-7:2014 covers welded

BS EN 10217-7:2014 covers welded stainless steel tubes used for circular cross-sections made of austenitic and austenitic-ferritic stainless steel

Important changes to BS EN 14607-6:2004 appearing in BS EN 16603-33-11:2019 are:

BS EN 81-77 specifies the special provisions and safety rules for passenger and goods passenger lifts where these lifts are permanently installed in buildings that are in compliance with EN 1998-1 (Eurocode 8)

as well as down-conductor systems are also referenced in this standard

BS EN 13010 lays down the requirements and the dimensions of the slot for pegboard display of unit packaging

Products and systems for the protection and repair of concrete structures. Test methods - Determination of the adhesion of injection products, with or without thermal cycling. Adhesion by tensile bond strength has-corrigendum BS EN 10217-7:2014 covers welded1 Scope This document describes a test method to determine the adhesion to hydraulic concrete of injection products. The test can be applied to polymer and cementetious injection products. The injection may be performed upon cracks in the dry, damp, wet or with water flowing through them. The tensile bond test should always be carried out after the appropriate period of curing under the standard conditions of test detailed below, but may additionally