2" PVC Push Point Compression Points ( Remove The point after

( Remove The point after marking the pipe)

This connector is used to connect 1-1/4" poly pipe to the shafts before the shafts are extracted from the ground

Then as the tool is driven through the ground the 3" drain cap actually pushes the pipe into the hole simultaneously as the Bullet Mole pierces the ground and advances under the pavement

The compression point is the first part to go through the ground and is attached to the shaft

As it proceeds

2" PVC Push Point Compression Points ( Remove The point afterThis part is used to insert a 2" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. It is threaded into the end of a 2 sch 40 PVC pipe or conduit. As it is screwed into the pipe it cuts its own threads on the inside of the pipe much like a tap. The outside diameter of the push point will be the same as the outside diameter of the pipe itself. Next this pipe point assembly is shoved into the same opening