2" Tappered Pull Connector Compression Points

2" Tappered Pull Connector Compression PointsThis connector is used to connect 2" poly pipe to the shafts before the shafts are extracted from the ground. This pull connector will make a secure and strong connection to any 2" rolled Polyethylene conduit for fiber optic Poly pipe for water lines or Polyethylene pipe for gas lines Etc (One size fits all types) It has a swivel between the two ends with lateral wobble. This unique design combination allows for the female threaded end of the

a piece of mule tape or masonary line is attached to a very strong magnet and is then lowered into the exit point and attached to the metal point

The tool can go further distances by just purchasing additional shafts

This is used to support the shafts and hold them up off of the ground while they are being driven in

If you are working with a different pipe

Stab the digging bar into one of the pre-drilled 2” holes of the 2x6x8 board on the bottom of the trench

1" Compression Point

It requires a very shallow and short entrance trench approx 6 Inches deep and 24 to 30 inches long depending on the angle

The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap

It breaks rocks

please reach out for the proper pull connector at: (888)-650-5554

Pelican Case

At a glance you will know if anything is missing