PrintDry Filament Dryer PRO3 titanium Extruder fan for the Craftbot

Extruder fan for the Craftbot 3

Use the 3D Printer Compatibility Chart below to determine which Bimetallic Heat Break™ is best suited for your application

this time using two screws for clamping instead of the one in E3D-v6

liquid glue for build plate will leave less residue on the printed model and is easier to clean up

The PTFE liner in Lite6 means that there is a temperature limit of 240C

PrintDry Filament Dryer PRO3 titanium Extruder fan for the CraftbotEasily adjust the temperature with 6 presets (35C, 45C, 55C, 65C, 75C, and 85C). Built in timer with a maximum time of 48 hours. Note: The temperature readings are directly measured at the tip of the temperature sensor, located about 15 mm away from the hot air vent. The temperature distribution inside the dryer is NOT uniform. The temperature in a place close to the hot air vent is higher and the temperature in a place far away from the hot air vent