Peugeot 2008 1.6 e-HDi 115 FAP panel filter Suspension 8mm pipework and fit from

8mm pipework and fit from the catalytic converter section backwards (Cat-back) these parts replace the centre and rear sections

Gauge Mounting Cup is an ideal accessory for the Turbosmart Boost Gauge

but when we tested the 3” flange up against an OE cat back we found that the flange on the OE cat back is only 78mm tall and with a 76mm hole this would only give 1mm each side for the gasket to seal which is not good enough and will most likely end with a leaking joint

The advantages are as follows

as the roll of the chassis is influenced in a positive manner

Peugeot 2008 1.6 e-HDi 115 FAP panel filter Suspension 8mm pipework and fit fromPanel type Unique Panel Dimensions 402mmX171mm