Specification for high expansion heat-resisting steel bar and wire for the manufacture of bolts, studs, set screws and nuts (Ni 25.5, Cr 15, Ti 2, Mn 1.5, Mo 1.25, Si 0.7, V 0.3) (limiting ruling section 50 mm) Ingestion-build-225643 - a seal status identification

- a seal status identification system

1 specifies the test procedures for discrete semiconductor devices

4] and Nd-Fe-B [5]

operating at rates of 100 kilobits/second or less

BS EN 16157-3:2018 includes some technical changes with respect to DD CEN/TS 16157‑3:2011

Specification for high expansion heat-resisting steel bar and wire for the manufacture of bolts, studs, set screws and nuts (Ni 25.5, Cr 15, Ti 2, Mn 1.5, Mo 1.25, Si 0.7, V 0.3) (limiting ruling section 50 mm) Ingestion-build-225643 - a seal status identification1 Scope This British Standard specifies requirements for high expansion heat resisting steel bar and wire in the following forms for the manufacture of bolts, studs, set screws and nuts. a) Bar with a diameter over 25 mm up to and including 50 mm and wire with a maximum diameter of 50 mm for machining: softened, cold worked, solution treated and machined or ground, designation HR 650A. b) Bar with a diameter over 25 mm up to and including 50 mm and