Festool 488543 FA-EHL Rabbet Depth Stop Product Collection_Century Components Magnum Series For use on hand-held routers

For use on hand-held routers

- the TPC 18 QUADRIVE Hammer Drill and the TID 18 Impact Driver together cover a wide range of applications with amazing power and performance

It does not need a high performance compressed air system

Product Characteristics

CMT's tenon cutting router bit will produce perfectly fitting tenons in every board you cut

Festool 488543 FA-EHL Rabbet Depth Stop Product Collection_Century Components Magnum Series For use on hand-held routersDial in consistent rabbets every time. The FA EHL Rabbet Depth Stop sets a repeatable rabbet depth so you can run accurate, uniform cuts pass after pass. It expands your HLC 82 into a precise rabbeting tool for joinery, trim, and edge work. Sets repeatable rabbet depths from 0 to 1 in (0 23 mm) Delivers accurate, uniform rabbets pass after pass Genuine Festool accessory for the HLC 82 and EHL 65 planers Pairs with the parallel side fence for fully