Spherical plain bearings - Thrust spherical plain bearings best-seller These coatings are intended for

These coatings are intended for the protection the inner and outer surfaces of steel tubes and their fittings (components) used as component parts of pipelines

PD IEC TR 62672:2018 supersedes PD IEC/TS 62672‑1:2013

This standard does not necessarily apply to equipment that combines protection and control functions in the same device sharing a single communication port

This British Standard supersedes BS 7083:1989

It is applicable to measurements normal to the coated surface as described in 7

Spherical plain bearings - Thrust spherical plain bearings best-seller These coatings are intended for1 Scope This part of ISO 12240 specifies dimensions and tolerances for thrust spherical plain bearings. The specified tolerance values apply to finished, thrust spherical plain bearings before any coating or plating. Thrust spherical plain bearings need not conform to the design illustrated but compliance is required as regards dimensions and tolerances specified. NOTE Thrust spherical plain bearings for airframe applications are not covered by this