1-1/4" PVC Push Point Compression Points It should be 5/8 of

It should be 5/8 of an inch long

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

This unique design combination allows for the female threaded end of the connector to be easily manuvered in order to quickly "FIND" the male thread of the shaft and be connected to it

The actual diameter of this part is 2" in

3) The connector with the attached pipe or conduit is lowered into the exit pit and the opposite end is connected to the male thread of the shaft without having to turn either the pipe or the shafts

1-1/4" PVC Push Point Compression Points It should be 5/8 ofThis part is used to insert a 1 1 4" PVC Sch 40 pipe into the ground after the initial hole is opened with the compression point. The point is screwed into the PVC pipe and cuts threads on the inside of the pipe much like a tap. The Push Point will have the same as the outside diameter of the pipe itself. After the Push Point is attached the pipe then this assembly is shoved into the hole made by the compression point. As it proceeds, roots or