Servo Lead/Terminal Crimping Tool Spare Tire Mount 2 x Servo Link Ball

2 x Servo Link Ball Cup

This slipper set is supplied pre-built and ready to install in your vehicle

5x63mm (powder coated steel) (assembled with hollow balls) (for use with #8140X TRX-4® Long Arm Lift Kit)

5830: Slash 2WD Low-CG Chassis Conversion Kit with installation hardware

ProTek RC CA Tire Glue w/Glue Tip (Medium)

Servo Lead/Terminal Crimping Tool Spare Tire Mount 2 x Servo Link BallProTek RC Servo Lead & Terminal Crimping Tool PTK 1999 The ProTek RC Servo Lead & Terminal Crimping Tool is the tool you need to make custom length signal wires for your ESCs, receiver batteries and servos. This tool safely secures the connector pins on wire sizes between 14 and 28awg, without damaging the pin or the wire. Simply strip a short length of the shielding off the wires, install the connector pin into the tool, insert the wire into the pin,