Safety rules for the construction and installation of lifts. Special lifts for the transport of persons and goods - Lifts for cranes Ingestion-build-100998

Safety rules for the construction and installation of lifts. Special lifts for the transport of persons and goods - Lifts for cranes Ingestion-build-1009981 Scope 1. 1 This document specifies the safety requirements for the construction and installation of power operated lifts attached to cranes and intended for access to workplaces on cranes, by authorised persons. This includes intended use, erection, dismantling, inspection and maintenance. The lift serves defined landing levels and has a load carrying unit which is: a) designed for the transportation of persons and goods; b) guided; c) travelling

The guidance of BS EN 13395-4 enables you to accurately conduct the test method to determine the workability of overhead repair mortars by giving you a detailed account of its apparatus requirements and the step-by-step procedure

BS EN 50518 on MARC is relevant to:

Products covered by this European Standard can be used for other purposes provided they comply with the relevant application standard

and identically distributed

shall be in a format suitable for adaptation to a European standardisation deliverable on Use Cases addressing the three areas of this request and highlighting their possible interdependencies

The object of BS EN 60512-16-13 is to detail a standard test method to determine if a wrapped connection has been made without damaging the wrapping wire

b) those making and buying pathstructures or kits

BS 4250 sets out the most up-to-date requirements relating to the use of commercial propane and butane gas

It should be used in conjunction with the generic specification IEC 61076‑1:2006 for product requirements and with IEC 62197‑1 for quality requirements as the basis for preparation of consistent detail product specifications for circular connectors

This document describes the current state of experts’ opinions on the standardization of metal halide lamps to cover the relevant parameters for hot restrike and for dimming in combination with low frequency square wave ballasts

6 mm to 6 mm

Note 2: This procedure is not applicable to materials with a dry-matter-content ratio lower than 33 %