1-1/2" Tappered Pull Connector Compression Points (1) Quick shaft

(1) Quick shaft

The push cap is attached directly to the PVC pipe that is ready to be installed after all of the Bullet Mole shafts are removed

or If there is no bell housing then a coupling must be glued onto the pipe and the part inserted into the coupling

It requires a very shallow and short entrance trench approx 6 Inches deep and 24 to 30 inches long depending on the angle

It is designed to absorb lateral forces that the point will experience as it comes in contact with debris from different angles along it's route

1-1/2" Tappered Pull Connector Compression Points (1) Quick shaftThis connector is used to connect 1 1 2" poly pipe to the shafts before the shafts are extracted from the ground. This pull connector will make a secure and strong connection to any 1 1 2" rolled Polyethylene conduit for fiber optic Poly pipe for water lines or Polyethylene pipe for gas lines Etc (One size fits all types) It has a swivel between the two ends with lateral wobble. This unique design combination allows for the female threaded end of the